#7367
UWnewbee - 10/04/2013 5:44 PM
if this ding is on the very outer edge the crucial point would be the starting of both threads,, but if its that minute as you say you could try a variable speed dremel tool with a fine grit small flat disk on a low speed, 1st plug the rest of the fitting with a rag, burnish off the ding carefully not cutting into the other threads and not taking too much stock off or you can alter the mating of both threads resulting in a cross thread. pull rag out an use tank pressure to blow clean,, you dont have to be in 50 years of law but atleast 25 years of being a machinist can help lol,, good luck